I have since also put this issue on the Lultzbot Community board and have yet to get any insight as to how to fix this.Īs an FYI - to correct your statement above, actually Cura 21.08 works fine on Python 2.7 which comes preinstalled on the older macs. So trying to get any kind of solution I ask if I could load the printer as a TAZ 5 and tweek it but got no real help there either. I got a too bad response without any direction as how to solve the issue. They also do not seem as helpful as the when the company was in Colorado pre-sale. Unfortunately they were not helpful. (See attached) Ever since the Lultzbot company was sold they do not seem to care about their earlier models or their very long time supporters. I did ask the Lulzbot support team since I'm certain that I'm not the only one that would still like to use 21.08. I tried rewriting or editing or duplicating the "ist" from the newer "ist" for the Lultzbot Cura 3.6.37 but nothing works.Īny help would be most greatly appreciated. I've tried downloading Python 2.7 which it was designed to use back then and can't download that on the new M2. So my question is how can I be able to open and use cura 21.08 on the new mac m2? After that I get you won't want to support issues or questions. I have too many printers to sit and manually plug in all the info into the new program versions. If you have a whole bunch of printers as I do, even the default setup is very time consuming. As anyone knows - for some reason occasionally (after 10 years I've found) Cura will wipe out the many printers and settings you have set them up all over again. Unfortunately the new Lultzbot Cura and the newer Ultimaker Cura do not have and options to select and load the older printers with their multitude of default settings. I like Cura 21.08 because on a few older Lultzbot Taz, this version has all the default settings for the older printers. I have read you do not support older versions and appreciate that but I just want to install it. I have read countless forums on Python and it's not their problem. You get python errors and request to changing "ist" which specifies the python location and version. Cura 21.08 will not open on a new mac M2 chip computer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |